Cisco CAPWAP

The recommended values for Cisco CAPWAP are listed in this topic.

Setting	Recommended Value
RRM—Dynamic Channel Assignment	Interval should be more than 8 hours. It is the typical duration of one nursing shift.
RRM—Dynamic Transmit Power Control	Enabled if honoring the maximum and minimum transmit power levels.
Transmit Power Threshold	Adjust to fit site.
Coverage Hole	Disabled—If Coverage Hole Detection is necessary, enable it with the following settings: Set Voice RSSI (-60 to -90 dBm) to -70 Set Min Failed Client Count per AP to 12
Aggressive Load Balancing	Disabled
Multicast Mode	Multicast, Direct Disable Mobility Multicast Messaging if multicast is not properly enabled in network. It causes one-way audio or no audio.
Multicast Tx Data Rate	Highest data rate. 12Mbps and 24Mbps as mandatory data rates.
Unicast-ARP	Disabled
WMM	B3000n: Enabled B3000: For Firmware release 3.1.1.11 or later—Enabled For Firmware release 3.1.1.11 or earlier—Disabled Smartphone clients—Enabled
U-APSD	B3000n—Enabled B3000: Disabled Smartphone clients—Enabled
DHCP Address Assignment (required setting)	Disabled
Symmetric Mobility Tunneling	Enabled
Priority Queue	Platinum
Client Load Balancing	Disabled
Band Select	Disabled
Frame Aggregation	Disabled on transmit or receive for Traffic ID 6 (voice) and 7 (network control)