|Working with Locations / Access Point Location Information|
Learn the steps for adding a new access point to a location in your enviroment.
In the following procedure, you will use the Begin Tour, End Tour, and Assign Location voice commands to assign access points to locations.
Before you begin:
If possible, make a map that shows the boundaries of the locations you have chosen for your facility, as well as the position and MAC address of each access point.
In the Administration Console, create all of the locations you need by completing the required fields in the Location Information tab. You can also associate locations with Neighbors during this process.
Make sure you are logged in to your badge as a member of a group with the Perform System Administration permission.
You can use voice commands on a badge to assign access points to locations only when you are at your home site.
To assign access points to locations:
If the Genie announced the name of the location, it means the access point is already assigned to that location, and the Genie bows out. If you want to change the location assignment, press the Call button, say "Assign Location" and then say the name of the location when prompted.
You can check whether a location is being reported accurately without starting another tour. To do this, press the Call button, wait for the Genie to answer, and then say "Where am I?" If you need to change the location name, use the Assign Location command.