How to Set Up an Isolated Access Point

  1. Attach an Ethernet crossover cable to the network port on the configuration computer.
  2. Connect the other end of the cable to the Ethernet port on the access point.
  3. If necessary, install configuration software for the access point on the configuration computer.
    Many access points require only a browser for configuration.
  4. Using the access point configuration utility, make sure your access point is set up as follows:
    • Allow open authentication (typically the default)
    • Turn off all security (typically the default)
    • Assign the SSID value as vocera(using all lower-case letters)
    • Allow a broadcast SSID to associate (typically the default)
    • Configure as an access point in infrastructure mode (typically the default)

    The exact procedure for setting up your access point depends upon the hardware manufacturer. Refer to your access point documentation for complete information.

    When Vocera badges come from the factory, their SSID property is set either to vocera or to <no value>. If you configure your access point as described above, both types of badges can connect to it.