Access Point Settings

Vocera requires specific access point settings and configuration recommendations to optimize wireless communication in your environment.

The following table displays the AP settings required for Vocera.

AP Feature Setting
Beacon Interval

The typical default beacon interval is 100 milliseconds.

For more information, refer to Beacon and Delivery Traffic Indication Map Intervals.

DTIM Interval

The default DTIM interval is 1.

For more information, refer to Beacon and Delivery Traffic Indication Map Intervals.

Data Rates

Enable data rate as per the requirement of your site.

For more information, refer to Data Rates.

SSID

Vocera recommends no more that 5 SSIDs.

For more information, refer to SSID.

Security Settings

Vocera devices support many security types.

For more information, refer to Security.

Peer-To-Peer Communication

For Vocera devices to work properly set the value to enabled on the access point or on the WLAN controller.

For more information, refer to Peer-To-Peer Communication.

Encryption

Vocera supports many encryption types.

For more information, refer to Authentication Overview for the best performance.

Channel Utilization

Radio Channel Utilization should be consistently less than 30%.

For more information, refer to Channel Utilization.

Channel Width

The channel width used are as follows:

For B3000n badge

  • 2.4GHz—20 Mhz
  • 5 GHz—20Mhz or 40Mhz

For V5000 Smartbadge

  • 5 GHz—20MHz, 40MHz, or 80MHz

For C1000 Minibadge

  • 5 GHz—20MHz, 40MHz, or 80MHz

Vocera recommends 20 MHz.