The B3000n and B3000 Badge is designed to automatically recover from problems that may
occur with its file system. Despite this safeguard, in very rare circumstances one or more
files on a Badge may become corrupted. When this happens, your Badge may continuously reboot,
or a Badge program may not start.
The B3000n and B3000 badges have two partitions: the main partition which is
read/write, and a backup partion which is read-only. When you run the REPAIR FILESYSTM
utility, the Badge checks the file system and repairs any corrupted files.
Note: You cannot repair the file system of Badges earlier than the B3000.
To correct a problem with a corrupted file and run the REPAIR FILESYSTM utility, perform
the following tasks available on the Badge Configuration Menu:
-
Display the Badge Configuration Menu.
-
Press the Down button to highlight the REPAIR
FILESYSTM command.
-
Press the Select button. The Badge displays the following
choices:
-
NO - CANCEL!
-
YES - REPAIR!
-
YES - WIPE N REPA
-
Do one of the following:
- Press the Down button to highlight YES -
REPAIR!
The Badge checks the file system and repair any corrupted files by copying
files from the backup partition to the main partition.
- Press the Down button to highlight YES -
WIPE N REPA
The Badge deletes all files from the main partition and copy all files from
the backup partition to the main partition.
-
Press the Select button.
-
Wait while the Badge reboots and then proceeds to update the file system. When the
update is complete (after a minute or two), the Badge reboots.