You can configure the remaining devices using the Badge Configuration Utility.
Using the BCU
To use the BCU, perform the following
tasks:
-
Locate and double-click the Vocera BPE Launcher icon on the
desktop.
The Badge Properties Editor UI
appears.
-
Attach a charged battery to a new device that has been reset to factory defaults.
The device automatically runs its Updater program if the
InstallDone property is set to False.
The Updater searches for a Badge Configuration Utility running
on 10.0.0.1 and connects to it.
-
Click Start BCU on the left pane.
The tab toggles to
Stop BCU.
The
Console displays the message
BCU launched
successfully, and the badge automatically starts the download process.
The Console continues to display messages
Initializing complete in <time taken to complete> ms after the
device downloads firmware and properties.
-
The badge automatically reboots and tries to connect to the network, using the SSID
and other network properties that it downloaded.
If successful, the badge tries to connect to the Vocera Voice Server that was
specified in the ServerIPAddr.
Validating the Connection
To validate the connection, perform the
following tasks:
-
Look at the screen of the device:
-
The message Logged Out indicates that the badge is
configured properly and has connected to the Vocera Voice Server.
Continue configuring the remaining devices. For more information, refer to
Configuring the Remaining Devices.
-
If the device does not display Logged Out within 30 seconds
to 60 seconds, the badge is not configured properly and did not connect to
the Vocera Voice Server. Continue troubleshooting the badges. For more information, refer to
Troubleshooting Device Configuration.
-
Shut down the BPE browser.
The session ends.