Basic Commands and Settings / Setting Device Properties |
When you use a headset, the badge automatically plays all audio through it by default.
Consequently, if you do not wear your headset all the time, you may not hear an incoming call or message announcement, and you may not know that someone is trying to contact you.
The Announce through Speaker property lets you customize that behavior:
Enabled—The badge provides call or message announcements through both the device speaker and the headset. These dual announcements ensure that you will always be notified of an incoming call, even if your headset is temporarily off. After accepting the call, the audio is through the headset only.
Disabled—The device plays both the announcement and the call or message through the headset.
If you turn on Announce through Speaker, you can leave your headset plugged in and put it on to communicate after you hear the announcement.
When your headset is not plugged in, all calls, messages, and announcements play through the speaker, as usual, regardless of the Announce through Speaker setting.
Use the following commands to control the Announce through Speaker property:
Action | Recommended Voice Commands |
---|---|
Play announcements through badge speaker when headset plugged in | Turn announce through the speaker on. |
Play announcements through the headset when headset plugged in | Turn announce through speaker off. |