|Manage / Access Point (AP) Locations|
You can use the, "Begin Tour", "End Tour", and "Assign Location" voice commands to assign specific access points.
If possible, make a map that shows the boundaries of the locations you have chosen for your facility, as well as the position and MAC address of each access point.
Make sure you are logged in to your device as a member of a group with permissions to perform system administration tasks.
Make sure you are at your home facility. You can use voice commands on a Vocera device to assign access points to locations only when you are at your home facility.
For guidelines on using voice commands, see the supported Device User Guide on the Vocera Devices page.
To assign access points using voice commands, follow these steps:
If the Genie announced the name of the location, it means the access point is already assigned to that location, and the Genie bows out. If you want to change the location assignment, press the Call button, say, "Assign Location" and then say the name of the location when prompted.
You can check whether a location is being reported accurately without starting another tour. To do this, press the Call button, wait for the Genie to answer, and then say "Where am I?" If you need to change the location name, use the "Assign Location" voice command.